Festool AG 125-14 DE, Руководство пользователя

Страница: 8 / 11

15
hand.
c) Do not position your body in the area where
power tool will move if kickback occurs. Kick-
back will propel the tool in direction opposite to
the wheel’s movement at the point of snagging.
d) Use special care when working corners, sharp
edges etc. Avoid bouncing and snagging the
accessory. Corners, sharp edges or bouncing
have a tendency to snag the rotating accessory
and cause loss of control or kickback.
e) Do not attach a saw chain woodcarving blade
or toothed saw blade. Such blades create fre-
quent kickback and loss of control.
Further safety instructions
-
The machine may not be used in damp and wet
spaces, outdoor when it is rainy, foggy or snowy
or in the explosive environment.
- Before use always inspect the fl exible lead and
the plug. Have the defects repaired by a spe-
cialist repair shop.
- Outside the premise use only approved exten-
sion leads and cable connections.
- Apply the machine to the material only when
switched on.
- Do not carry the machine by the lead.
- Do not work on a ladder.
-
When operating the tool, use protective gloves
and tough footwear.
- When operating the tool, use goggles and ear
protectors.
- The dust generated during work is harmful to
health. When operating the tool, use the dust
extraction system and the respirator.
- Materials containing asbestos can only be pro-
cessed by qualifi ed individuals. Comply with the
safety regulations that apply in your country.
- Flexible power supply cable always route from
the tool backwards.
- Only use milling rings recommended by the
manufacturer.
- The machine is only allowed be used when pro-
tective guard is in place and additional handle
is fastened.
-
Plug in the fl exible power supply cable’s plug
into the wall socket when the machine is off.
- Make yourself sure whether the material that is
going to be machined does not contain electric,
water or gas lines – an injury could occur.
- Do not mill over metal objects, nails or screws.
- The machine is not allowed to be operated by a
person under 16 years of age.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated re-
sidual current of 30 mA or less.
- When clamping, be careful about the direc-
tion of rotation marked on the label and/or the
diamond tool, which must be the same as the
direction of the actual rotation of the machine
used.
-
The fl ange and fastening nuts must be properly
tightened.
- Use a tool with specifi cations suitable for the
worked material – cf. the information on the
diamond tool and its packaging.
- Avoid mechanical damage to the diamond tool,
whether by force, impact or heat.
6 Emission levels
Measured values determined according to EN
60 745.
Typically the A-weighted noise level of the tool
are:
Sound pressure level: 90 dB (A)
Sound power level: 101 dB (A)
Inaccuracy of measurement K = 3 dB (A)
CAUTION
Operating noise
Damage to hearing

Use ear protection!
Measured values determined according to EN
60 745.
Vibration emission value
a
h
= 4,0 m/s²
Inaccuracy of measurement K = 1.5 m/s²
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!