3. Installation
3−8
Festo P.BE−MPAL−EN en 1008NH
External pilot air supply
If the operating pressure lies below 3bar or abo ve 8 bar,
pilot control of the solenoid coils must be operated with
an external pilot air supply.
Note
·
Use preferably closed−loop regulated external pilot air.
Reliable faultless operation of the valve terminal is then
possible, e.g. even with fluctuating operating pressure.
·
The external pilot air supply is supplied centrally for all
solenoid coils via pilot connections(12/14) on the right−
hand end plate. This also applies when the valve ter
minal is operated with two pressure zones.
·
For external pilot air supply the pilot air pressure must
be adapted to the operating pressure, but only within
the values of 3 ... 8 bar .
The conversion between the internal and external pilot air
supply is described in Chapter
3.3.2
Valve terminal MPA−L with pressure zone separation
The pressure zones are separated from each other by special
sub−bases (see Chapter 1.5.5). Each pressure zone must be
supplied by pneumatic supply plate and via a right−hand end
plate with side connections with compressed air. The position
of the supply plate within the pressure zone (left, centre or
right) is arbitrary.
By fitting a second supply plate within a pressure zone you
can provide additional supply air and exhaust air to optimise
the ventilation and exhaust performance of the valve ter
minal.
For each additional pressure zone a special sub−base is re
quired for separation and a special pneumatic supply plate is
required for supply (see Fig.3/1 and Fig.3/2).
Содержание MPA-L Series
