Festo CPX-FB33, Руководство по эксплуатации, Страница: 18 / 40

18 Festo — CPX(-M)-FB33/34/35/43/44/45 — 2022-05f
Parameterisation
Detailed description of the specific parameters and basic principles for application è CPX system
description CPX-SYS-….
Parameter lists of the various CPX modules
è
Descriptions of the modules.
8.1 Bus node parameters
Bus node parameters Description/setting options
Standard CPX parameters
–
SCS monitoring
–
SCO monitoring
–
Monitoring U
OUT
–
Monitoring U
VAL
–
SCV monitoring
–
Fail-safe
–
Force mode
–
System start with external parameters or
default parameters or with saved parameters.
–
Diagnostic memory
Standard CPX parameters – for further informa-
tion
è CPX system description CPX-SYS-…
Note
The parameters of the diagnostic memory can
only be set via the CPX-MMI or CPX-FMT.
Device-specific parameters
Diagnostic message filter
Undervoltage U
OUT
/U
VAL
–
Only available for bus nodes from Rev 14.
–
Displayed in the hardware configuration (HW
Config) as "Filter Alarm U
off
/U
ven
".
–
Inactive:
Undervoltage is reported via the network
–
Active:
Undervoltage messages are filtered and not
reported over the network
è the under-
voltage is only indicated by the flashing SF
LED on the bus node.
Channel alarm filter
Undervoltage U
OUT
/U
VAL
–
Only available for bus nodes from Rev 20.
–
Displayed in the hardware configuration (HW
Config) as "Filter channel alarms U
off
/U
ven
".
–
Inactive:
Undervoltage is reported via the network.
–
Active:
Undervoltage messages are filtered
è
a max-
imum of one message per module is sent over
the network; the undervoltage is additionally
displayed by the flashing SF LED on the bus
node.