37 / 49
Festo 7DGC-Kb_en
9. Move the piston module backwards and forwards so that the sealing band
in the slot is pressed upwards and fi xed into place.
Standard linear drives (DGC-K-18-…-GK)
1. Press the two covers into the front sides of the piston module.
2. Stretch the wiper seal over the two covers of the piston module.
Linear drives with an extended piston module (DGC-K-18-…-GV)
1. Press the two covers into the front sides of the piston module.
2. Stretch the O-ring over the two covers of the piston module.
10. Insert all four pressure supports between the cylinder barrel and the sealing
band.
11. Push the end cap module into the cylinder barrel while pushing the sealing
band through the slots in both end cap modules.
Note
The sealing band should be fl ush with the end cap modules, otherwise it
cannot be correctly attached to the clamping components.
12. Apply LOCTITE 243 to the self-tapping screws.
13. Tighten the self-tapping screws of the end cap module to a tightening
torque of 7 Nm _10%.