Festo 1095933, Руководство по эксплуатации

Страница: 24 / 104

EHMB
Festo EHMB 1008a English
24
3. Push the aligned rod eye
aJ
onto the
connecting bolt
aA
on the EHMB.
4. Fasten the cylinder holder (Z) to the
threaded holes with 4 screws and
2 centring sleeves.
The cylinder retainer can also be mounted
on the sides (A) and (C) of the EHMB.
To attach to the side (A), the front cover
must be removed and the sensor holder
(only for EHMB−20
è Fig. 14) must be
modified. The tightening torque for the
cylinder retainer is summarised in the
table below.
EHMB−... 20 25 32
Screw M4 M4 M5
Tightening torque [Nm] 2.9 2.9 5.9
Centring sleeve dia. 7x3 dia. 7x3 dia. 9x4
Fig.8
Carrying out the product installation
Note
External stops can cause the toothed belt to tear due to excessive forces.
· Use only the motor controller to brake the rotation.
Note
Eccentric masses can destroy the bearing.
· Note that the front side (A) ( è Fig.9) is permissible only for attachment with
a symmetric applied load.
· Position the EHMB so that your control sections are accessible.
· Fasten the EHMB to the threaded hole with 4screws and 2centring sleeves or
with the aid of kits.
Fig.7
(A)
(Z)
aJ
(C)
aA