Fervi T066, Руководство по эксплуатации и обслуживанию

Страница: 21 / 44

MACHINES AND
ACCESSORIES
Page 21 of 44
Reversing rotation
Reversing rotation can take place by means of the micro switch located next to the spindle or
by means of the button on the control panel. In any event, only reverse rotation at low speed
MAX 150 rpm (levers in position L1).
Anticlockwise rotation is activated only if the knob is in the manual position.
On the right side of the head there are two knobs for
engaging the automatic descent (ref. 15 in Figure 9) and
for setting the speed of descent (ref. 16).
Figure 9 – Automatic descent
adjustment
Automatic descent
The automatic descent can only be used in drilling mode and with a low spindle rotation
speed: MAX 560 rpm (lever ref. 22 in Figure 6 in position L).
The knob (ref. 18 in
Figure 10
Figure
10
allows the movement of the vice slide to be
locked.
The two screws ref. 17 hold the table in place, to adjust the
inclination it is necessary to unscrew them and slightly
rotate the table (± 90°) referring to the graduated scale at
the attachment point, and then tighten the locking screws
again.
The same screws must be removed to allow the table to be
turned upside down and for the use of the vice.
Figure 10 – Table rotation and
slide lock.
18
17
16
15
fervi.com