MACHINES AND
ACCESSORIES
Pagina 28 di 32
Figure 17 - Changing the bandsaw blade.
2. Using a screwdriver, remove the fixing screws of the rear protection guard (see
Figure
16
and ref.28 in
Figure 17
/C) and remove it.
3. Turn the blade tensioner lever (see ref.29 in
Figure 16
and
Figure 17
/D) to the "-"
position to release the blade tension.
4. Extract the saw blade (ref.30
Figure 17
/D).
5. Insert the new blade into the saw, paying attention to the cutting direction and first
placing it between the blade guide rollers and then between the rubber pulleys (ref.31
Figure 17
/D).
6. Turn the blade tensioner lever again (see ref.29 in
Figure 16
and
Figure 17
/D) to the
"+" position to put the blade under tension. Moving the lever all the way, the blade will
automatically go into cutting position when the motor begins to turn.
7. Remount the guard (see
Figure 16
and ref.28 in
Figure 17
/C) and the angular plate of
the moveable blade guide (see ref.27 in
Figure 16
and
Figure 17
/B).
First cut with new blades
To preserve the effectiveness of the blade over time, do not use maximum cutting pressure
during the first 4-6 cuts.
B
A
D
C
fervi.com
