MACHINES AND
ACCESSORIES
Pagina 24 di 32
4. After selecting the desired angle, tighten
the angle locking nut (ref. 16
Figura 11
).
5. Fit the reference rod into the hole (ref.17 in
Figure 12
) and secure it with the headless
screw (ref.18 in
Figure 12
).
6. Loosen the knob (ref.19 in
Figure 12
) and
slide the movable rod (ref.20 in
Figure 12
)
determining the desired cutting height.
7. Tightly lock the knob (ref.19 in
Figure 12
).
Figure 12 – Reference bar
1. Insert the piece / section bar to be cut within the clamp (ref.4 in
Figure 1
) resting it
against the piece stop element and tightening it by screwing the clamp actuation lever
(ref.3 in
Figure 1
).
Adjust the position of the guide blade unit (see
Figure 13
and ref.11 in
Figure 1
) that,
in addition to being a useful guide for the band saw, also acts as a protection device to
cover the part of the blade that does
not serve the purpose of cutting.
In this regard, loosen the lever (ref. 21
in
Figure 13
) by turning it anti-
clockwise, slide the blade guide unit to
the desired position (the one that
leaves the blade uncovered as little as
possible) and relock the lever to secure
the unit in position.
Figure 13 - Close-up of the blade guide unit.
2. Set the cutting speed of the cutting machine by
adjusting the knob of the speed controller (see
Figure
14
).
Figure 14 - Cutting speed knob.
18
19
17
20
16
fervi.com
