Not for
Reproduction
1.
Remove the foot pedal (A, Figure 39) from the pedal mount
tab (B).
39
2.
Remove the pedal mount hardware (C) and rotate the tab
180 degrees.
3.
Reinstall the pedal mount hardware and tighten securely.
4.
Reinstall the foot pedal on the pedal mount tab in the proper
orientation as shown in Figure 39.
Floor Pan Removal & Installation
This unit is equipped with a removable floor pan which can be
removed to provide better access to the mower deck.
1.
Loosen and remove the retaining hardware (A, Figure 40)
that secures the floor pan to the frame of the unit.
40
2.
Tilt the back end of the floor pan up and then remove it from
the unit.
3.
To re-install the floor pan: Reverse the removal procedure.
Neutral Adjustment
The neutral system for this mower consists of two neutral linkage
rods and a pivot that connects the ground speed control lever
to the transmission. The lower rod that connects the
transmission to the pivot is factory preset and should not be
changed for neutral adjustment purposes. The adjustment is
achieved by changing the length of the upper rod (A, Figure 41)
that connects the ground speed control lever to the pivot.
41
Determining if Adjustment is Necessary: If the zero-turn rider
"creeps" while the ground speed control levers are locked in
the NEUTRAL LOCKOUT position, then it may be necessary
to adjust the linkage rods.
Note: Perform this adjustment on a hard, level surface such as
a concrete floor.
1.
Disengage the PTO, engage the parking brake and turn off
the engine.
2.
There are two nuts (B) on the linkage rod. Loosen the nuts
from the ball joints (C) and turn the linkage rod to adjust.
• If the machine creeps forward, turn the rod clockwise
(while standing at the rear of the machine, facing
forward);
• If the machine creeps backward, turn the rod
counter-clockwise (while standing at the rear of the
machine, facing forward).
3.
Lock the jam nut against the ball joints when neutral is
achieved.
Note: This adjustment should not be performed while the
machine is running. It may take several attempts to achieve
neutral, depending on how much the machine creeps.
Return-to-Neutral Adjustment
Prior to performing this procedure the Neutral Adjustment
Procedure must be completed.
29
Содержание IS600ZB2544
Страница 1: ...N o t f o r R e p r o d u c t i o n...
Страница 42: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 43: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 44: ...N o t f o r R e p r o d u c t i o n...
