Not for
Reproduction
Checks Before Starting
6
• Check that crankcase is filled to the full mark on the dipstick
(A, Figure 6). See the engine Operator’s Manual for engine
oil dipstick location, oil fill instructions, and oil
recommendations.
• Make sure all nuts, bolts, screws, and pins are in place and
tight.
• Fill the fuel tank (B) with fresh fuel. Refer to engine manual
for fuel recommendations.
• Check the hydraulic oil tank (C) and make sure that the oil
level is up to the FULL COLD mark.
Starting the Engine - Carbureted Models
WARNING
If you do not understand how a specific control functions,
or have not yet thoroughly read the
Features & Controls
section, do so now.
Do NOT attempt to operate the unit without first becoming
familiar with the location and function of ALL controls.
1.
Engage the parking brake and make sure the PTO switch
is disengaged and the forward speed control lever is in the
NEUTRAL position.
2.
Set the engine throttle control to FULL throttle position.
Then fully close the choke by pulling the knob OUT fully.
NOTE: A warm engine may not require choking.
3.
Insert the key into the ignition switch and turn it to the
START position.
4.
After the engine starts, gradually open the choke (push
knob down fully). Reduce to half throttle speed and allow
to warm up. Warm up the engine by running it for at least
a minute before engaging the PTO switch or driving the
mower.
5.
After warming the engine, ALWAYS operate the unit at
FULL THROTTLE when mowing.
In the event of an emergency the engine can be stopped
by simply turning the ignition switch to STOP. Use this
method only in emergency situations. For normal engine
shut down follow the procedure given in STOPPING THE
MOWER
Starting the Engine - Fuel Injected Models
WARNING
If you do not understand how a specific control functions,
or have not yet thoroughly read the
Features & Controls
section, do so now.
Do NOT attempt to operate the unit without first becoming
familiar with the location and function of ALL controls.
NOTE: To prime a dry fuel system, turn the key switch to ON
position for one minute. Allow fuel pump to cycle and prime
system. Turn the key switch to OFF.
1.
Engage the parking brake and make sure the PTO switch
is disengaged and the forward speed control lever is in the
NEUTRAL position.
2.
Position the engine throttle control midway between the
SLOW and FAST positions.
3.
Insert the key into the ignition switch and turn it to the
START position. Release switch as soon as engine starts.
If starter does not turn engine over, shut off key switch
immediately, and consult engine operator's manual.
Warm
up the engine by running it for at least a minute before
engaging the PTO switch or driving the mower.
4.
After warming the engine, ALWAYS operate the unit at
FULL THROTTLE when mowing.
In the event of an emergency the engine can be stopped
by simply turning the ignition switch to STOP. Use this
method only in emergency situations. For normal engine
shut down follow the procedure given in STOPPING THE
MOWER
Stopping the Mower
1.
Gently squeeze both drive levers (A, Figure 7) evenly to
stop the unit.
14
Содержание FW35 Series
Страница 1: ...N o t f o r R e p r o d u c t i o n ...
Страница 40: ...N o t f o r R e p r o d u c t i o n ...
