16
T380D-T430D
Rev. 1.0
SAFETY RULES
02-SICUREZZA
GENERALE
2 SAFETY RULES
2.1 General safety rules
The machine was designed and manufactured according to appropriate safety standards. Before using the machine,
carefully follow all the precautions and instructions contained in the manual in order to avoid accidents.
►
Ensure that, on the ground where you are to work, there are no large stones or rocks, protruding tree stumps,
metal elements of any kind (mesh, wires, cables, chains, tubes, etc.).
►
Carefully follow the instructions for the adjustment of the machine height above ground.
►
While working with the machine, ensure that there are no persons or animals within a radius of at least 50
metres.
►
Never work “flush to the ground” on wet terrain. In these conditions, in fact, there is a risk of taking too much
power from the motor, filling the rotor protective casing with pressed mud, and causing excessive wear on the
flails and the drive belts, thereby compromising machine output and equilibrium.
►
A tractor of appropriate power must be adopted for each machine. If a tractor with a power greater than the
machine maximum absorbable power is used, use a PTO shaft with a clutch (torque limiting device), without
which damage can be caused to the drive unit and the flail shaft.
►
Examine the safety decals applied on the machine and described in this manual. To work safely, clean them
and, if they are not legible, replace them with new decals.
FERRI declines all liability for damage caused by improper use of the machine.
WARNING
Carefully check the machine before each start-up.
CAUTION
Before starting up the machine or carrying out maintenance work, carefully read all the
instructions and safety messages contained in the manual and on the machine. Carefully
follow all the accident prevention and safety rules.
CAUTION
►
Before starting to use the machine you must be familiar with all its devices, controls and functions.
►
Make sure that all the safety devices are in good condition and in the correct position. In the event of faults or
damage, replace them immediately.
►
Before getting off the tractor and before each maintenance operation, apply the parking brake, switch off the
engine and remove the ignition key from the dashboard.
►
The user is responsible for the maintenance of the machine.
►
It is the responsibility of the owner to provide all the instructions to operators or employees before operating on
the machine, according to regulations of the destination country.
►
Only an operator who is adequately trained and instructed on the safety rules can operate on the machine.
Содержание T380D left
