FERREX HL520, Руководство пользователя

Страница: 32 / 38

AUS
Text
28 AFTER SALES SUPPORT

support@scheppach.com.au

1300 855 831
MODEL: HL520 PRODUCT CODE: 700726 04/2021
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
XIV. ELECTRICAL CONNECTION
The electrical motor installed is connected and ready for operation. The
connection complies with the applicable Australian standards.
The customer's mains connection as well as the extension cable used must
also comply with these regulations.
Important information
In the event of an overloading the motor will switch itself off. After a cool-down pe -
riod (time varies) the motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is often damaged.
This may have the following causes:
• Passage points, where connection cables are passed through windows or doors.
• Kinks where the connection cable has been improperly fastened or routed.
• Places where the connection cables have been cut due to being driven over.
• Insulation damage due to being ripped out of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not be used and are life-threat-
ening due to the insulation damage.Check the electrical connection cables for
damage regularly.
Make sure that the power is switched off before inspecting the cable. Electrical
connection cables must comply with the applicable Australian standards and must
be correctly marked. Only use connection cables with the marking ''H05VV-F''.
Replacement cables can only be fitted by an approved and certified electrician. If
you are in any doubt please contact the help line at the foot of this page.
AC motor
• The mains voltage must be 220 - 240 V~
• Extension lines up to a length of 25 m must have a minimum cross section of 1.5
mm², lines with a length exceeding 25 m must have a minimum cross section of
2.5 mm².
Connections and repairs of electrical equipment may only be carried out by an
electrician.
Please provide the following information in the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
AUS
Electrical connection