Ferno 101-H, Руководство пользователя, Страница: 8 / 19

Model 101-H Operating Table
8
© Ferno-Washington, Inc 234-1994-03 October 2010
Assembling the Table
4 - asseMbling THe Table
4.3 Tools required
3/16" Allen Wrench 1 ea.
9/16" Wrench 1 ea.
Rubber Mallet 1 ea.
Tape Measure 1 ea.
4.1 general information
The table top and the table base (with cover) are shipped
in separate cartons. To assemble the table, follow the
instructions on this page and page 9.
Notee: Two people will be needed to lift the table top onto the
table base during assembly.
4.4 Preparing the Table base
1. To lock the wheels, step on the end of the wheel-lock
pedal nearest the foot pedals. (See Using the Wheel
Locks , page 10.)
2. Pump the left pedal (Figure 2) to raise both jacks to
their full height. Do not pull up on the jacks to raise
them. Stop pumping when the jacks stop moving
upward.
Notee: Raising the jacks to their full height will provide
easier access to the underside of the table top later in the
assembly procedure.
4.2 Hardware Provided
The hardware used to attach the table top to the base (Figure
1) is shipped in a bag attached to one of the mounting
brackets on the underside of the table top.
3/8" Hex Head Cap Screw 2 ea.
3/8" Flat Washer 2 ea.
3/8" Split Lock Washer 303 SS 2 ea.
1/4" Socket Head Cap Screw 2 ea.
1/4" Flat Washer 2 ea.
Figure 2 - Raising the Table Top
Figure 1 - Hardware Supplied
Hex Head Cap Screws
Socket Head
Cap Screws
1/4" Flat Washers
3/8" Flat Washers
3/8" Split Lock Washers
important
Pulling up on the jacks to raise them can force air into the
hydraulic system. Always use Only the left pedal to raise
the jacks. If one or both ends of the table will not raise to
the maximum height, see Troubleshooting, page 14.