Page 8
DUO
DUO
DUO
DUO
DUOX CITYLINE KIT 1-2L
X CITYLINE KIT 1-2L
X CITYLINE KIT 1-2L
X CITYLINE KIT 1-2L
X CITYLINE KIT 1-2L
DUO
DUO
DUO
DUO
DUOX CITYLINE KIT 1-2L
X CITYLINE KIT 1-2L
X CITYLINE KIT 1-2L
X CITYLINE KIT 1-2L
X CITYLINE KIT 1-2L
•
Once having completed the terminal's configuration, we recommend deactivating
the MASTER panel to avoid accidentally reprogramming terminals.
•
The panel
deactivates itself from master mode
following the same activation
procedure: 3 quick presses of the
SW1
button. A deactivation bop sounds after 2
seconds.
Configuration - Programming the Amplifier
The DUOX amplifier can be configured to allow for the operation as a general entrance,
block entrance or sub-block entrance.
•
The DUOX system uses 6 digit house terminal addresses.
•
These call code digits are organised as follows:
BBSSNN
:
- BB:
indicates the Block number, (from 00 to 99).
- SS:
indicates the sub-Block number, (from 00 to 99).
- NN:
indicates the sub-block's house number, (from 00 to 99).
You do not have to segregate the installation according to this hierarchy since the
system adapts to the installation's needs.
•
The kit panels are a special case and only allow a range of 1 to 2.
IMPORTANT NOTE:
Configuration of the parameters by the installer.
To configure the Cityline push button panel see
ANNEX: Voice assisted configuration
in button panels.
Instructions included with this equipment.
You can also configure it by temporarily connecting a keypad ref. 7439, download the
Direct Video Duox Panel Programming Manual, cod. 97900 at www.fermax.com.
Panel Connectors:
•
System Connection Terminals:
B,B
: DUOX Bus: telephone/monitors power, data, audio and video.
C, NO, NC:
relay contacts,
2A@30Vdc
(door opener connection).
+12:
12 Vdc-250mA output
(maximum 500mA for 100 seconds).
BS, -:
entrance hall button.
S, -:
door sensor input.
+, GND
: Not available Future versions.
P1-P2: buttons connection.
E)
F)
Individual connection buttons for Cityline continuous profile panel
G)
OneToOne Module Connection
CN2
CN3
Select language for “open door” message and voice assisted con-
figuration messages.
See CODING at the end of SECTION I. Installation manual.
H)
ON
B
D
A
C
E
F