Ferm SGM1011, Оригинальное руководство пользователя

Страница: 5 / 140

EN
5
• never spray at persons ­ Never aim the
nozzle at another person or animal. Never
allow the spray to come into direct contact
with the skin.
• flash point ­ This spray gun must not be
used for spraying flammable paints and
solvents with a flash point of less than 55 °C
• Ventilation ­ Always make sure that there is
adequate ventilation in the work area when
spraying.
• Basket nozzle ­ Always keep the spray
basket nozzle in place during use.
• Consider work area environment ­ Do not
use spray guns where there is a risk of fire or
explosion.
• Beware of any hazard ­ Beware of any
Hazard by the material being sprayed and
consult the markings on the container or the
information supplied by the manufacturer.
• Do not spray ­ Do not spray any material
where the hazard is not known.
• Use eye protection ­ Always use appropriate
eye protection to keep hazardous vapours or
fumes out of the eyes.
• Wear a mask ­ Never operate a spray gun
without wearing a face mask.
• Protect your ears ­ Wear ear protectors if the
sound pressure exceeds 85 dB(A).
• maintain your tools ­ Keep your spray gun,
paint container and nozzles clean. Do not
clean with flammable liquids with a flash point
less than 55 °C Inspect the mains lead
periodically and if damaged have it replaced
by a qualified person.
• naked flames ­ Never spray near a naked
flame or appliance pilot flame.
• smoking ­ Never smoke whilst spraying.
• Thinning ­ Always read the paint
manufacturers thinning recommendations or
instructions before using paint or other
materials.
• Disconnect from the mains supply ­ Always
disconnect from the mains supply when filling
the paint container or cleaning the spray gun.
• switch off when not spraying
­ Avoid
running the unit with the flow rate knob fully
closed for any length of time.
We accept no responsibility for damage
caused by the use of unsuitable
substances, or paints that have not been
thinned correctly, and any health hazards
that arise from lack of adequate
ventilation.
Immediately switch off the spray gun when:
• Interruption in the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation
Electrical safety
When using electric tools, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock and personal injury.
Read all these instructions before attempting to
operate this product and save these instructions.
Always check that the mains voltage
corresponds to the voltage on the rating
plate.
Class ll machine. Your machine is double
insulated; therefore no earthwire is
required.
replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
2
. When using a cable
reel always unwind the reel completely.
3. Operating instructions
Preparation
Fig. B
Do not use textured wall paints or
coatings as this will block the nozzle.
To obtain the best results, it is important that you
prepare the surface to be sprayed and thin the
paint to the correct viscosity, before you operate
your spray gun. Always ensure that the surfaces
to be sprayed are free from dust, dirt and grease.
Make sure that you have masked the areas that
should not be sprayed, using a good quality
masking tape. The paint or fluid to be sprayed