Ferm PSM1027, Оригинальное руководство пользователя

Страница: 5 / 92

5
EN
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
2
. If you use a extension
cable reel, always fully unroll the cable.
Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important
that it is correctly destroyed and replaced by an
approved BS 1363/3A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown
live
As the colours of the wires in the mains cable
of the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
Technical data
Mains voltage 230 V~
Mains frequency 50 Hz
Power input 135 W
No-load speed 10,000/min
Protection class IP 20
Weight 1.3 kg
NOISE AND VIBRATION
Sound pressure (Lpa) 73 dB(A) K=3dB
Acoustic power (Lwa) 84 dB(A) K=3dB
Vibration 12.11 m/s
2
K=1.5 m/s
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your finishing sander has been designed for
sanding wood, metal, plastics and painted
surfaces.
1. On/off switch
2. Lock-on button
3. Sanding pad
4. Sanding paper clamp
5. Main grip
6. Auxiliary grip
7. Dust extraction connection
ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting and removing the sanding paper
(sanding paper clamps) (fi. B1)
Mounting
• Open the sanding paper clamps (4).
• Mount sanding paper (8) with the required
grain size onto the sanding pad (3). Make
sure that the perforation in the sanding paper
(8) corresponds with the perforation on the
sanding pad (3).
• Fold the sanding paper (8) at both ends around
the edges of the sanding pad (3).
• Close the sanding paper clamps (4) one by
one. Make sure that the ends of the sanding
paper (8) are clamped.