Ferm PDM1045P, Оригинальное руководство пользователя, Страница: 4 / 92

4
EN
2. MACHINE INFORMATION
Intended use
Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.
Technical specifications
Mains voltage 220-230V~
Mains frequency 50 Hz
Power input 1050W
No-load speed (1) 0-1,000 /min
No-load speed (2) 0-2,800 /min
Impact rate (1) 0-16,000 /min
Impact rate (2) 0-44,800 /min
Max. chuck size 13 mm
Max. drill diameter
Wood 30 mm
Concrete 20 mm
Steel 13 mm
Weight 3.2 kg
Noise values
Sound pressure (L
PA
) 94 + 3 dB(A)
Acoustic power (L
WA
) 105 + 3 dB(A)
Vibration values
Drilling into metal, a
h,D
2.59 + 1.5 m/s
2
Impact drilling into concrete, a
h,ID
9.00 + 1.5 m/s
2
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
- using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
page 2.
Fig. A
1. Chuck
2. Function selection switch
3. Depth stop
4. Lock-on button
5. On/Off switch
6. Speed adjustment wheel
7. Left/right rotation switch
8. Gear selection switch
9. Side handle
Fig. B
10. Rear sleeve
11. Front sleeve
3. OPERATING
Impact drills require very little operator
pressure. Excessive pressure on the tool
can lead to unnecessary overheating of
the motor, and burning of the driven tool.
Mounting and removing the auxiliary grip (fig. A)
Mounting
• Loosen the auxiliary grip (9).
• Slide the auxiliary grip (9) over the chuck (1).
• Turn the auxiliary grip (9) to the required
position.
• Tighten the auxiliary grip (9).
Removing
• Loosen the auxiliary grip (9).
• Remove the auxiliary grip (9) from the chuck (1).
• Tighten the auxiliary grip (9).
Exchanging and removing drill bits
Fig. A - B
The machine is suitable for use of the following
drill bits:
• Wood (HSS)
• Metal (HSS)
• Concrete / masonry (hard metal)