Ferm FAG-125/1050, Руководство пользователя

Страница: 8 / 80

GB
8 Ferm
3. ASSEMBLY
Prior to mounting an accessory always
unplug the tool.
Assembling the hand grip
Fig. 1
The hand grip is suitable for either left or right-
handed use.
Turn the hand grip (3) to the notch on the right •
side of the machine for left-handed use.
Turn the hand grip (3) to the notch on the left •
side of the machine for right-handed use.
Turn the hand grip to the notch on the top of •
the machine to use it vertically.
Mounting a grinding disc
Fig. 2
Use grinding discs of the correct dimension. Use
fibre reinforced grinding discs only.
The grinding disc must not touch the edge of the
guard.
Press the spindle lock (6) and turn the spindle •
(9) until it engages in the lock. Keep the
spindle lock pressed during this procedure.
Remove the flange nut (12) from the spindle •
using the spanner (11).
Position the grinding disc (7) on the flange (5). •
Place the flange nut on the spindle an tighten •
it using the spanner.
Release the spindle lock and check that the •
spindle is unlocked by rotating it.
Mounting grinding discs and roughing discs
Fig. 3 and 4 show how to mount the flange (10)
when using thick (4 - 8 mm) and thin
(2,5 - 4 mm) discs.
The following grinding discs can be used with this
grinder.
For deburring: grooved, fibreglass reinforced •
type 27. Dimensions Ø 125x6.0x22.2 mm.
For slitting/ cutting: grooved, fibreglass •
reinforced, type 41 and type 42. Dimensions
Ø 125x3.0x22.2 mm.
If you use normal grinding discs they
should always be fibreglass reinforced.
4. USE
Always follow the safety instructions
and keep to the applicable regulations.
Hold the machine away from the workpiece when
turning it on and off because the grinding disc
could damage the workpiece.
Clamp the workpiece firmly or use another •
method to ensure that it cannot move while
working.
Check the discs regularly. Worn grinding discs •
have a negative effect on the machine’s
efficiency. Change to a new grinding disc in
good time.
Always first turn the machine off after use •
before removing the plug from the socket.
Deburring
Fig. 5
An angle of inclination of 30º to 40º will give the
best results when deburring. Move the machine
back and forth using light pressure. This will
prevent the workpiece from discolouring or
becoming too hot and will avoid making groves.
Never use abrasive cutting discs for
deburring work!
Cutting
Fig. 6
Maintain firm contact with the workpiece to
prevent vibration and do not tilt or apply pressure
and when cutting. Use moderate pressure when
working, appropriate to the material that is being
worked on. Do not slow down grinding discs
by applying sideways counter pressure. The
direction in which you want to cut is important.
The machine must always work against the
direction of the cut; so never move the machine
in the other direction! There is the risk that the
machine will catch in the cut causing kickback and
that you will lose control.
The ON/OFF/ switch
Fig. 1
Switch ON
Use one finger to push the lock button forward
and then press the switch.