Ferm bsm1023, Оригинальное руководство пользователя

Страница: 5 / 92

5 Ferm
EN
Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/5A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
TECHNICAL DATA
BSM1023
Mains voltage V~ 230
Mains frequency Hz 50
Power input W 950
No-load speed m/min 380
Sanding belt size mm 75 x 533
Sanding pad size mm 76 x 135
Protection class IP 20
Weight kg 3.65
NOISE AND VIBRATION
BSM1023
Sound pressure (L
pa
) dB(A) 92.3
Acoustic power (L
wa
) dB(A) 103.3
Uncertainty (K) dB(A) 3
Vibration (main grip) m/s
2
2.31
Uncertainty (K) m/s
2
1.5
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
60745; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (fIg. A)
Your belt sander has been designed for rough
sanding applications on wood, metal, plastics and
painted surfaces.
1. On/off switch
2. Lock-on button
3. Sanding pad
4. Sanding belt roller
5. Clamping lever for sanding belt
6. Centring knob for sanding belt
7. Main grip
8. Auxiliary grip
9. Dustbag connection
10. Carbon brush holder
11. V-belt cover
ASSEMBLy
3
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the sanding belt
(fig. A & B)
Mounting
● Place the machine on its side with the V-belt
cover (11) facing downwards.
● Release the clamping lever (5).
● Mount a sanding belt (12) with the required
grain size around the sanding pad (3) and the
sanding belt rollers (4). Make sure that the arrow
on the inside of the sanding belt points in the
same direction as the arrow on the housing.
- Use a coarse sanding belt (grain 50) for
sanding rough, uneven surfaces.
- Use a medium sanding belt (grain 80) for
removing the remaining scratches from the
coarse sanding belt.