Ferm Industrial HDM1040P, Оригинальное руководство пользователя

Страница: 4 / 56

4
EN
Use of extension leads
Only ever use approved extension leads that are
suitable for the power rating of the machine. The
minimum core thickness is 1.5 mm
2
. Whenever
using a reel extension lead, always fully unroll the
lead.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.
2. MACHINE INFORMATION
Intended use
The demolition hammer is intended for demolishing
concrete, chiseling off concrete, grooving and bar
cutting.
Technical specifications
Mains voltage 220-240 V ~
Mains frequency 50 Hz
Power input 1.200 W
Impact rate 3.100 /min
Number of chisel positions 12
Weight 6.22 kg
Sound pressure (L
PA
) 94 dB(A) K=3 dB(A)
Acoustic power (L
WA
) 105 dB(A) K=3 dB(A)
Vibration
Main grip a
h,Cheq
12.550 m/s
2
K=1.5m/s
2
Auxiliary grip a
h,Cheq
15.876 m/s
2
K=1.5m/s
2
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardized test given in EN60745. It may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
• The times when the tool is switched off or
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
page 2
Fig. A
1. On/off switch
2. Power indicator
3. Lock-button
4. Chuck
5. Locking sleeve
6. Main grip
7. Auxiliary grip
8. Chisel position lock ring
9. Lubrication point
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the accessory
Fig. B
Do not use blunt drill bits or chisels.
Immediately sharpen or replace blunt
drill bits or chisels.
This machine is fitted with an SDS Max
chuck.
Mounting
• Apply a few drops of oil to the shaft of the
accessory.
• Slide the locking sleeve (5) to the rear.
• Insert the accessory into the chuck (4).
• Release the locking sleeve (5).
• Push the lock ring (8) forward and turn to
desired position. Make sure the ring locks
back in place before using the machine.