16
THE MENU INFORMATION
Press MENU key on the RCU to display the following menu on the non-menu mode. The menu consist
of 6 sub-menus such as the following:
1.
Installation
2.
User Preference
3.
Utility
4.
Channel List Edit
5.
System Setting
6.
Timer Setting
1. Installation
1.1 Satellite
Select the desired satellite by using arrow keys. You can also press OK
key to display a draw-down list, the pre-programmed satellites is list
here. You can select one or more satellites by using arrow keys, and
press OK to confirm. The selected satellites will be marked with the
symbol.
By pressing the right arrow
, you can go to the editing of the satellite.
To save your changes press EXIT. You'll return in this manner to the list
of satellites.
1.2 Antenna Config
LNB Type:
Select the desired option among WideBand, User, Standard
and Universal1.
High Frequency:
The settings can be altered using the numeric
buttons.
Low Frequency:
The settings can be altered using the numeric keys.
LNB Power:
If your receiver is connected to the LNB, select YES. But if
your STB is connected to another receiver through Loop Through support,
you should check which receiver is connected directly to the LNB. In case
the other receiver is directly connected to the LNB, then select OFF.
Swith:
switching system settings.
Positioner:
motorized dish settings.
1.3 Switch
The individual satellite can be allocated directly to a DiSEqC position. Please select the proper your
cable installation switch and port option
1.4 Positioner
The settings is for the motor control of the satellite antenna. These only apply to an antenna with
corresponding function USALS or DiSEqC 1.2.
Caution:
Leave the setting-up of the motor control to properly-trained personnel. Otherwise
the satellite equipment may not function correctly.
