23
5. ASSEMBLY & INSTALLATION
Before assembling the stand, please take a look
at the list below. Your stand comes with the fol-
lowing parts and mounting hardware.
Short angle brace:
2-pcs
Shorter angle brace:
2-pcs
Long angle brace:
2-pcs
Longer angle brace:
2-pcs
Round head bolt M8 ×
12:
32-pcs
Hex nut M8:
32-pcs
Flat washer 8:
32-pcs
Hex bolt M6
×
16:
4-pcs
Flat washer:
4-pcs
Rubber feet:
4-pcs
5.1 Stand assembly
Take the two short and the two longer angle
braces out of the box and put it on the floor.
Now take the four legs upside down, and attach
them to the four braces using M6 × 12 nuts and
bolts. (Finger tighten) See Figure. 1
Fig. 1
Attaching legs to the braces
Now, mount the two other longer and the two
short angle braces to the legs with the help
of the nuts and bolts, (Finger Tighten). See
Figure. 2
Fig. 2
Attaching the middle braces to the legs
Now, turn the stand upright and adjust the legs
so that they are evenly positioned, tighten all
the screws well.
5.2 Installing the router table on the
stand
Take the router table and put it upside down
on the floor or bench. The router table and the
upper braces of the stand feature 4 holes to
mount the router table to the stand. Position
the stand inverted, on the router table so that
the holes are aligned and then mount it with
the help of washers and bolts provided, (Finger
Tighten). See Figure. 3
Fig. 3
Mounting the stand to the router table