Notice: The above-mentioned parameters (tested by 2500mAh Ni-MH battery in Lab) are
approximate and may vary between headlamps, batteries and environments.
Operation Instruction
Light turning on/off
Depress the button switch in the top of the battery case to turn the light on/off;
General mode
When turn on the light, it will enter into the general mode automatically. Depress and hold the
button switch (for over 1 second), the light can select brightness levels in the order of
High
→
Low
→
Mid
→
Cycle. The light can memorize the working brightness level within 1 second;
Mode selection
When the light is on, a fast double depress on the button switch can transfer between the general
mode and the SOS flashing mode.
Battery Specifications
Type
Dimensions
Nominal
voltage
Usability
Ni-MH battery
AA
1.2V
Recommended
√
Alkaline battery
AA
1.5V
Usable
√
Non-rechargeable battery
(Lithium)
AA 1.5V Usable
√
Rechargeable battery
(Li-ion)
14500 3.7V Banned
×
Battery Replacement
Unscrew the tail cap (the side without the button switch) to put in the battery with the cathode
side
(-) toward the tube bottom, screw the tail cap back on to test.
Usage and Maintenance
◎
Please do not disassemble the sealed head, doing so can cause damage to the light and will
void the warranty.
◎
High-power light should use battery with high current discharge capability; We suggest using
high-performance Ni-MH rechargeable battery, using alkaline battery will decrease the runtime of
this high-intensity light.
◎
Please use batteries of high quality, and take out the battery if you do not use the light for a
long time, or the light can be damaged by electrolyte leakage or battery explosion which is caused
by low quality battery.
◎
The o-ring may be worn out after using for a long time. If it happens, please replace the o-ring
with a new one to keep the light properly sealed against water.
◎
Please clean the contacts of your light from time to time, especially if the light flickers or
doesn't light up. There may be several reasons for a flickering or not working light:
Reason A: The battery needs replacing.
Solution: Replace the battery (Please confirm the correct installation of anode and cathode).
Reason B: The threads, PCB board contact or other contacts are dirty.
