9
I
USE OF THE 6 ORDER MODE THROUGH THE PILOT CONDUCTOR
If your installation is controlled by the Tempo EDF type controller (French Electrical
Companies), the decrease of temperature values Comfort 1 or Comfort 2 will be made
according to the order of this controller in compliance with a tariff season.
The following 6 orders are in question: Comfort, ECO, Comfort 1, Comfort 2, Anti-Freeze
Mode and Stop (see the table in Chapter 4).
x
Comfort 1
induces the temperature decrease by –1°C in respect of the Comfort
position.
x
Comfort 2
induces the temperature decrease by –2°C in respect of the Comfort
position.
NOTES:
- The functions Comfort 1 and Comfort 2 enable to decrease the power consumption
through the programming centre which carries out a tariff administration according to the
TEMPO EDF type contracts.
-
As your convector is equipped with an electronic thermostat for 6 orders,
the changes controlled by the controller and the programming device are not
immediate; it is necessary to wait for approx. 15 seconds before they are processed
.
x
Exceptional use
:
deviation of the convector from programming
Regardless the order sent from the programming centre or the controller you can make the
following settings yourselves:
If the room is permanently used, for example by a sick person, it is possible to
maintain permanently the comfort temperature (set the switch to the Comfort
position), except the cases when the orders Anti-Freeze Mode or Stop are
transmitted.
If the room is not used (for example a guest room), it is possible to maintain the
temperature at a very low level (the switch is set to the Anti-Freeze Mode position),
except the case when the order Stop is transmitted.
In both the foregoing cases, it is necessary to set the switch again to the
PROGRAMMING position after the exceptional use is cancelled.
¨
NOTE
: If your installation is equipped with a performance limiter, the limiting is
a priority; your convector need not heat, although the switch is set to the Comfort position.
When the limiting is finished, the convector will start heating again.