Vehicle's Battery
SIREN
SPEAKER
100w
SIREN AMP
COLOR
FUNCTION
CONNECTION
Black
Ground / 12v (-)
Chasis Ground
Red
Battery / 12v (+)
Positive Battery Terminal
Yellow
Mode 1 / 12v (+)
Switch/Controller
Brown
Mode 2 / 12v (+)
Switch/Controller
White
Park Kill / 12v (+)
Park-Kill Signal
Green
Speaker
Siren output to speaker**
Gray
Speaker
Siren output to speaker**
Blue
Tone Select / 12v (+) Momentary Switch
**Not polarity dependent
SPECIFICATIONS, TONES, & WIRING
WIRING DIAGRAM
WIRING INSTRUCTIONS
1)
Connect the red 12v (+) wire to the positive terminal
of the vehicle's battery. Ground the 12v (-) black wire or
connect it to the 12v (-) terminal of the vehicle's battery.
2)
Connect the yellow wire for mode 1 and brown wire for
mode 2 to individual latching switches.
3)
This unit can function as a standalone speaker utilizing
internal tones or it can utilize tones from an external siren:
3a)
If connecting to an external siren, connect the
green wire & gray wires to the speaker output wires
from the siren amplifier. These connections are not
polarity dependant.
3b)
If utilizing the internal siren tones, simply apply
power to the yellow wire for mode 1 or brown wire
for mode 2 to activate the selected tone (see page
4 for steps to change internal siren tones).
INSTALLATION NOTES
1)
To rebroadcast tones from an existing remote siren,
apply 12v (+) to the yellow wire (mode 1) on the Hammer
and it will rebroadcast the remote siren's tones in low
frequency mode. Out of the box, the Hammer's mode 1
is defaulted to a "silent tone" for use with external siren
amplifiers. There is a silent tone available for mode 2 if
desired (see page 4 for steps to change internal siren
tones).
2)
To use the internal tones of the Hammer without the
use of an external siren, simply activate mode 1 or mode 2
(see below for steps to change internal siren tones).
SIREN TONE SELECTION
1)
Connect the Siren to the battery, attaching the red
12v (+) wire to the positive terminal of the vehicle's battery.
Ground the black wire or connect it to the 12v (-) terminal
of the vehicle's battery.
2)
Connect the mode wire you would like to program to the
positive terminal of the vehicle's battery.
3)
Momentarily tap the Tone Changer wire (blue) to the positive
terminal to change tones.
The Hammer is loud and can be harmful to your hearing.
Hearing protection is recommended when testing this product.
The Hammer will only broadcast internal and/or external tones
for 60 seconds at a time.
If the Hammer is connected to an external siren amplifier and
detects an active siren tone, it will always override the internal
tones on the Hammer. This behavior will occur in both mode 1
and mode 2.
FENIEX
// INSTRUCTION MANUAL
WEB
//
www.feniex.com
6
TM
