FREQUENTLY ASKED QUESTIONS
1) How do I know if there is power to my 4200 Relay?
A flashing green LED light on the PCBA will indicate if there
is power to the board if the firmware is fully operational.
2) Why can’t I program to outputs 1 - 2?
Outputs 1 - 2 are only for the WigWag Function Box.
3) My controller does not turn on after I programmed it?
Make sure to provide 12V+ into the "Ignition Input" (Input
H).
4) What is the password for Feniex Bluetooth Module?
Android: The password is: 1111
Apple: The password is: 11111111
5) Can I still use my high beams with the WigWag
function?
Yes, please use the wiring diagram (see fig. 7.1) as a
reference.
• To program, select Input C, D, or E
• Select “Highbeam Override” (see right, fig 7.2).
6) How do I use my wig wag option?
Each output will support 1 high beam light assembly. This
option can be used for low beams. Make sure to wire each
output to the positive side of the high beam or low beam.
Be sure to completely cut the wire to not splice into it to
percent feedback.
7) How do I wire the "highbeam" function from the
vehicle?
Run the "switch side" wire, after its cut off from the
high beam bulb, into the 4200's input (C,D or E). In the
programming software, select the input of the vehicle's
highbeam wire and on the left column of the programmer
under "Wig Wag Function" select "high beam" override.
8) My controller button is not illuminating?
Make sure to provide 12V+ into Input G (day mode).
9) The program software will not acknowledge my 4200
controller.
Make sure the 4200 control panel is plugged in via
provided USB to the computer.
10) Can I change button labels on the App for handheld
device?
Yes. If using Android app, press and hold button on
handheld device. Enter new name for button when text
box appears. On Apple app, select “settings” to edit labels
on buttons.
TM
FENIEX //
INSTRUCTION MANUAL
WEB //
www.feniex.com
15
