- 8 -
FDM-4000i Manual V1.0
DEVICE Programming and Setup
To setup and program the Encoder you can use the
GUI interface
or the
LCD Front Panel
Connecting to the GUI Interface:
Connect an Ethernet cable directly (
no Cross Over cable required
) to the Web Management
Port on the rear panel of the Encoder or connect the Ethernet cable to an Ethernet switch.
Connect an Ethernet Cable to your PC.
Static IP address
A static IP address must be used on the computer you use to configure the Encoder.
Refer to the computer’s operating software documentation for assistance on using static
IP addresses.
Starting GUI Interface
Open a web browser window
Enter
“http://192.168.1.9”
in the web address field
Note:
To setup the encoder using the Front Panel LCD see
“
Modulator Configuration via Front
Panel LCD”.
