8
The SRM 6302 / 8302 has a variety of
connectors on its input / output panels.
Below is a chart listing the various types
and their pin outs.
Before using the SRM 6302 / 8302,
please read and follow the steps listed
below:
1.
IMPORTANT
Heed all safety warnings when
operating the SRM 6302 / 8302.
2. Make sure the power switch is in the OFF position
and all volume levels are in the 0 position.
3. Next, plug the supply cord into a power source
with the correct voltage.
5. Connect the speaker cables from the SRM 6302 /
8302 PA out jacks to the input jacks of the speaker
cabinets.
6. Connect the cord(s) from any outboard gear,
microphones or other signal source(s) to the
appropriate input jack(s) on your SRM 6302 /
8302's.
7. First, turn all outboard gear, instruments and other
equipment ON, then the SRM 6302 / 8302.
8. Increase volume controls and effects level controls
to their desired levels, listening for feedback or
ringing.
9. When shutting down the SRM 6302 / 8302, turn
OFF the SRM 6302 / 8302 first then any additional
outboard gear, instruments or other equipment.
For more detail on setting up your SRM 6302 / 8302,
please refer to the diagrams on pages 10 thru 13.
BASIC SETUP OF YOUR SRM 6302 / 8302
Jack
MIC
INPUTS
Style
Connection
Pin Out
Balanced
Input
XLR
Female
Pin 1 = GND
Pin 2 = POS
Pin 3 = NEG
PA 1,
PA 2,
EFFECTS
INPUTS
1/4" TS
Tip = Input Signal
Sleeve = GND
LINE
INPUTS
1/4"
TRS
Tip = POS Signal
Ring = NEG Signal
Sleeve = GND
TAPE
IN / OUT
Dual
RCA
Inner Ring = Signal
Outer Shell = GND
FOOT
SWITCH
1/4" TS
Tip = Signal
Sleeve = GND
Balanced
Input
Unbalanced
Input
Switch
Unbalanced
Input /
Output
MAIN,
MONITOR,
EFFECTS
OUTPUTS
Tip = Signal Output
Sleeve = GND
1/4" TS Unbalanced
Output
Tip = Signal
Sleeve = GND
PA 1,
PA 2
OUT
1/4" TS
Speaker
Output
INPUT / OUTPUT CONNECTIONS
