SR6300 / SR8500 Powered Mixers®™
(These are the model name for warranty claims)
5
SERVICE NOTES
FRONT PANEL REMOVAL is accomplished by
removing the 6 screws from the front. It helps to
remove the “PROGRAMS” and “MAIN MAS-
TER” knobs for leverage to pull the panel from
the chassis. Clip the wire tie and remove the
two connectors (CON5 + CON6) to completely
remove the front panel. Ensure that all wires
are re-attached onto wire tie point to prevent a
safety hazard.
REAR PANEL REMOVAL is accomplished by
first removing the front panel as in # 1. There
are 6 screws in the rear panel that must be re-
moved; after which the rear panel including
power supply and power amplifier can be re-
moved.
EFFECTS board is permanently connected to
the main mix board (NOT the input section, an
additional board on the front panel). The effects
board is part of the main mix module. To re-
move this module, remove the knobs, nuts and
washers from the “PROGRAMS” and “MAIN
MASTER” controls. There are 5 connectors on
the board that must be disconnected for full re-
moval of effects and main mixer section.
PCB REMOVAL is generally not necessary
since part replacement is done at the module
level only.
POWER AMPLIFIER MODULE REMOVAL is
accomplished by removing the screws on the 4
corners of the heatsink (which is part of the
module). Remove connectors from CON1,
CON2, CON7 and DC FAN.
MODULE EXCHANGE POLICY
If a failure due to one of the modules is
detected, please contact the Fender® Dealer
Customer Service Department to order the
complete Module Assembly.
