MUSTANG
™
III/IV/V (V.2)
1.
To save a preset you should first modify an existing preset,
for example, by turning any of the programmable knobs,
such as GAIN.
2.
Press the SAVE button. The SAVE and EXIT buttons should
be illuminated. You can press EXIT at this point to cancel
the save process.
3.
Turn the DATA WHEEL select a preset destination to
overwrite.
4.
Press the DATA WHEEL if you want to edit the name of
your new preset. Use the buttons to perform the functions
listed along the bottom of the screen; turn the DATA
WHEEL to select characters.
5.
Press the SAVE button a second time to confirm the save.
Guitar Tuner
Your Mustang™ amplifier has a built-in Tuner mode that turns
the screen into a guitar tuner.
To use the Tuner:
1.
Press and hold the TAP button. The TAP and EXIT buttons
will illuminate.
2.
Strike any single string on your guitar and watch the
screen. The note of the string being tuned is displayed
along with a fine tuning needle.
"In tune"
3.
Turn the tuning peg on your guitar until the fine tuning
needle indicates the string is in tune, as shown above.
4.
Standard guitar tuning is as follows:
5.
Press EXIT or TAP to exit from the Tuner.
Footswitches
Four-Button Footswitch (0080996000)
Connect a 4-button footswitch to your Mustang amplifier
(included with the Mustang IV & V, optional equipment for the
Mustang III) to enable remote multi-function foot control. The
footswitch display and LEDs show some of the same informa-
tion as the amplifier screen, so you can, for example, tune
your guitar and select presets by watching the footswitch
without ever looking at the screen onboard the Mustang!
• Select Quick Access presets (QA1/QA2/QA3)
• Select presets (up/down/bank)
• Bypass effects
• Activate the Tuner
Mode indicators
The footswitch has three modes that are identified by the
three LEDs labeled
MODE 1
,
MODE 2
and
MODE 3
. The
footswitch also has a Tuner mode which is indicated when all
of the mode LEDs are off.
To switch between modes, press the MODE button. To acti-
vate Tuner mode, press and hold the MODE button.
♫
You can lock the 4-button footswitch in Mode 1, 2 or 3
using the Utility menus, to prevent accidental Mode
changes (see Utility Menus, page 12).
• Mode 1—
In Mode 1 the footswitch is used to select one of
three Quick Access presets, using the buttons labeled:
QA1 /
QA2 / QA3
(in line with the MODE 1 LED). When you select a
Quick Access preset, the number of the preset will appear in
the display of the footswitch.
♫
You can any assign any preset to be a Quick Access
preset in the Utility menus. (see Utility Menus, page 12).
• Mode 2—
In Mode 2 the footswitch is used to select presets
down/up, or in banks of 10, using the buttons labeled:
DOWN
/ UP / BANK
(in line with the MODE 2 LED). When you select a
preset, the number of the preset will appear in the display of
the footswitch.
9
f e n d e r . c o m
