2.0
2
f e n d e r . c o m
Getting Started
Introduction
This manual is your step-by-step guide to the Fender® FUSE™
software for your Mustang™ or G-DEC® 3 amplifier. Fender
FUSE allows you to control your amplifier from your computer
and to perform many functions beyond what the amplifiers
provide on their own. System requirements: To run Fender
FUSE, you must have a PC computer running Windows 7, Vista
or XP, or a Macintosh computer with Intel® processors running
OS X version 10.5 (Leopard) or above.
Installing Fender® FUSE™
To install Fender FUSE on your computer please download
the latest version of the Setup file from
http://www.fender.
com/support/gdec3/
or
http://www.fender.com/support/
mustang/
.
To install Fender FUSE:
1.
Double-click on the Fender FUSE Setup.exe file (for PC) or
the FUSE Installer.dmg (for Mac) and follow the onscreen
instructions.
2.
If any device drivers or auxiliary program windows pop up
during the Fender FUSE installation process, always allow
them to be installed. Examples:
Firmware Update
Your Mustang or G-DEC 3 amplifier may need a firmware
update to operate properly with Fender FUSE.
To update the Firmware on your Mustang amplifier:
1.
Connect your Mustang amplifier to your computer's USB
port and open the Fender FUSE software.
2.
Turn the amplifier off.
3.
MUSTANG I/II:
Press and hold the SAVE button on the
amplifier while turning the power switch back on. Continue
holding the SAVE button until it starts to blink
red
.
4.
The Firmware Update Instructions will automatically open
and give you two options. Select the "Bundled Update"
option unless you have downloaded a newer firmware
update from
http://www.fender.com/support/mustang/
.
5.
Turn the amplifier off and then back on again to finalize
the firmware update.
To update the Firmware on your G-DEC 3 amplifier:
1.
Download the latest firmware file from:
http://www.
fender.com/support/gdec3/
. To check what version your
G-DEC 3 currently is running, watch the start up screen on
the G-DEC 3 and the firmware version number will display
in the lower right corner for 3 seconds after the initial
Fender logo screen (for example, "v 1.03").
2.
Unzip the compressed file that you just downloaded,
which contains the firmware update file.
3.
Connect your G-DEC 3 amplifier to your computer's USB
port.
4.
Open Fender FUSE and click on "Update Firmware" from
the Utilities menu (under Main Menu).
5.
Select the firmware update file that you downloaded and
unzipped in Step 2.
6.
Watch the G-DEC 3 screen for update progress. Firmware
update takes about 20 seconds.
Select "Run"
Select "Install"
Select "Bundled Update"
Содержание G-DEC 3 MUSTANG FUSE 2-0
Страница 1: ...2 0 ...
