Fender Blues-Junior III, Руководство пользователя

Страница: 7 / 20

7 7
fender.com
Rear Panel Rear Panel
Specifications Specifications
TYPE:
PR 295
PART NUMBERS:
223-0500-000 (120V, 60Hz) 223-0501-000 (110V, 60Hz) TW
223-0503-000 (240V, 50Hz) AUS 223-0504-000 (230V, 50Hz) UK
223-0505-000 (220V, 50Hz) ARG 223-0506-000 (230V, 50Hz) EUR
223-0507-000 (100V, 50/60Hz) JPN 223-0509-000 (220V, 60Hz) ROK
POWER REQUIREMENT:
180W
POWER OUTPUT:
15W RMS minimum into 8Ω at 5% THD, 1kHz
INPUT IMPEDANCE: 1MΩ
TUBES PRE-AMPLIFIER : 1–Fender Groove Tube 12AX7 (P/N 001-3341-000) 2–Fender Groove Tubes 12AX7 (P/N 007-0228-000)
OUTPUT : 2–Fender Groove Tubes EL84 (P/N 004-1255-000)
FUSE:
Internal (non-user serviceable)
SPEAKERS:
1–12" 8Ω Fender Special Design "lightning bolt" speaker by Eminence® (P/N 007-9527-000)
FOOTSWITCH (OPTIONAL): 1–button, FAT switch (P/N 099-4049-000)
DUST COVER (OPTIONAL): Fitted cover (P/N 005-4912-000)
DIMENSIONS HEIGHT :
16 in (41 cm)
WIDTH : 18 in (46 cm)
DEPTH : 9 13/16 in (25 cm)
WEIGHT:
31 lb (14.1 kg)
Product specifications are subject to change without notice.
I. POWER CORD —
Connect to a grounded outlet in accordance
with the voltage and frequency ratings specified on the rear
panel of your amplifier.
J. FOOTSWITCH JACK —
Plug in a footswitch (optional
equipment) to enable remote selection of the FAT boost circuit.
The FAT switch {C} on the control panel is disabled when the
footswitch is connected.
K. SPEAKER JACK —
Connection for the internal speaker –or– an
8Ω external speaker cabinet.
!
An 8Ω speaker load must always be connected to the Speaker
jack when the unit is ON to prevent damage to the amplifier.
L. TUBE STABILIZER —
A shock-absorbing stabilizer is installed
on the output tubes to minimize the tube vibration and
microphonics that normally develop over time. The stabilizer
can be used with all output tubes compatible with your Blues
Junior™ III amplifier.
M. FENDER® GROOVE TUBES® — Your new Blues Junior III
amplifier comes equipped with the highest quality tubes
available, sourced from various manufacturers worldwide.
Because of occasional irregularities in supply, the specific tube
type used in each amplifier is subject to change without
notice.
When replacing the EL84 output tubes, please note the specific
tube markings on the original tubes factory supplied with
your amplifier. For example, EL84 output tube types include,
but are not limited to: GT-EL84-R; GT-EL84-S; ST-EL84-R; etc.
The installation of a different type may require significant
adjustment by a qualified technician to avoid reduction in
performance and tube life.
Additionally, Fender Groove Tubes tests and
sorts our EL84 output tubes based on their
measured performance. The sorted tubes are
labeled with a fine rating of 1–10 and may also be
labeled with a coarse rating color of BLUE, WHITE
or RED. A pair of matched EL84 output tubes with
the same fine rating (and coarse rating, if applicable) as
the original tubes will be the perfect replacement. However,
replacement tubes with a fine rating within one number of the
original tubes can be used without rebiasing the amplifier.
If you have questions or concerns, please contact your Fender
dealer or authorized service center.
N. FUSE (NOT SHOWN) — In the unlikely event of an electrical
fault, your Blues Junior III amplifier is protected by an internal
fuse. If the unit should suddenly stop working, take it to an
authorized service center to have the fuse replaced and the
cause of the electrical fault inspected.