17
Remote controller
• Open the device back cover.
• Insert the CR2 battery, take care about correct polarity.
• Return the cover to its original position.
• Switch on the controller by red button in the front.
The remote controller is not waterproof, keep it in a dry place.
After switching on the controller and if no energizers are paired, then different
device symbols flash alternately on the side of the display. This only means
that no energizer has been paired yet. Pairing described on page 20, chapter
8.2 Pairing.
8. CONTROL
fencee
power DUO RF PDX
models behave similarly to fencee DUO PD, but with several states
for radio communication operation added. Switching between states is done using the button
on the energizer. Transitions between states are indicated on the diagram below.
OFF State
The energizer is completely off. It consumes almost no energy.
It is not possible to control it remotely. No LED is active.
ON State
The energizer produces impulses and communicates with the remote controller.
Status LED is lit (adapter) or flashing (battery).
BLUE colour – 100 % output
PURPLE colour – 50 % output
RED colour – error
OFF state RF active - Standby mode
The energizer does not produce a pulse, but it can be controlled remotely.
The status LED flashes every 3 seconds.
BLUE colour – normal state
RED colour – low battery voltage
Pairing mode
Special mode designed for assigning the energizer to the remote control.
Status LED flashes BLUE very quickly.