3.7.
INSTALLATION AND ADJUSTMENT OF BAR HOLDER (OPTIONAL Fig. 4)
a. Install the guide rod (19) in the hole on the base.
b. Tighten nut (20).
c. Slacken the handwheel (21) and position the holder (22) at the required distance.
d. Tighten the handwheel (21).
3.8.
CUTTING FLUID SYSTEM (Fig. 6)
NOTE
To prepare the cutting fl uid, use special
cutting oils indicated in table.
a. Prepare 8.5 litres of water-oil emulsion
(concentration ratio: 10%).
b. Pour the contents directly into the tank of
the pump (30).
DANGER - WARNING
NEVER USE THE MACHINE WITHOUT
CUTTING FLUID.
4. USE
DANGER - WARNING
THE MACHINE IS FITTED WITH A MAINS SWITCH (31 - FIG. 7) TO BE ACTIVATED
BEFORE CARRYING OUT KIND OF WORK OPERATION. ONCE WORK HAS BEEN
COMPLETED, TURN OFF THE MAINS SWITCH (31A - FIG. 7).
DANGER - CAUTION
• Never wear gloves during the machine cutting phase.
• Before commencing a new cut, always remove the cuttings left from the previous
task.
• Keep hands well away from the cutting zone.
DANGER - WARNING
RUNNING IN THE BLADE: PERFORM A CORRECT RUNNING-IN PROCEDURE
AS INDICATED IN THE HEADING “BLADE REPLACEMENT”.
4.1.
ADJUSTING BLADE TENSION (Fig. 3)
Turn the handwheel (2) clockwise till reaching the green fi eld “X”. Optimum position end of
green fi eld.
DANGER - WARNING
IF THE BAND TENSION IS TOO HIGH THE BELT MAY JUMP OUT OF THE
GUIDES.
AGIP
OXALIS
CASTROL
SUPER
CHEVRON
EP
ESSO
KUTWELL
MOBIL
SOLVAC
SHELL
DROMUS
TOTAL
LACTUGA
IP
UTENS
TABLE OF OILS
BRAND
TYPE OF OIL
32
EN
