Femco WEATHERBRAKE 2175, Инструкция по эксплуатации

Страница: 7 / 8

1. Assemble door latches as shown using two (2) 1/4” x
3/4” bolts and nuts.
2. Position under bottom rear of door.
3. Door is to be set firmly in loop of door latch. Change
position up or down with adjustment holes if necessary.
4. Mark location for one (1) of the two (2) holes and drill
one (1) 9/32” diameter hole.
5. Attach to fender using one (1) 1/4” x 1” bolt and nut.
6. Tighten all bolts.
DOOR LATCH
1. Mark location of holes in windshield to left window (A).
2. Cut 5/8” slots next to wire frame of left window and at-
tach to windshield using two (2) #10 x 3/4 bolts and
nuts.
3. About 6” from back of left window at location (B) cut
5/8” slots in left window and door and attach using one
(1) #10 x 3/4” bolt, nut & clip.
4. Tighten bolts.
LEFT WINDOW
A
1. Right window is to be bent to conform to side arm by
placing on a table and bending by hand.
2. Using same procedure as left window, attach right win-
dow to windshield and side arm using three (3) #10 x
3/4” bolts, clips and nuts.
3. Tighten bolts.
RIGHT WINDOW