Unverferth 2070
— Set Up
1-97
Weather Guard Tarp Installation (Optional)
(Continued)
FIG. 1-176
Fixed Tube
Weldment
(273382)
Rivet/Pop
3/16”
(9003378)
Plug
9005088
Attaching Tarp
1.
On a clean floor, lay the tarp out flat with the raw edge of the hems and pockets
down and the exterior side facing up. (FIG. 1-176)
2.
Insert the small fixed 1 1/8” tube (273382) by sliding it into the small pocket of the
tarp. Leave 1” of the tube sticking out one end and drill a 3/16” hole through the
center of the outer reinforcement strap and tube. Fasten with a rivet (9003378). At the
other end, pull on the tarp by hand to stretch it until there is 1” of tube sticking out.
Drill hole and install rivet. Press the 1 1/8” plugs (9005088) into each end of the tube.
FIG. 1-176.
INSTALLATION TIP: Tarp is designed to be stretched the length of the tube to reduce wrin-
kling. For easier assembly, apply liberal dusting of baby powder on tube and inside of tube
pockets before sliding tubes in pockets.
3.
Insert the 2” roll tube into the large pockets, with the splined shaft to the rear. Measure
11 5/8” ffrom the end of the spline to the start of the tarp. Install the first U-clamp
(9004949) and self-drilling screws (9005197) to the first reinforcement strap,to secure
the tarp to the tube. Work down the roll tube putting the U-clamps and self-drilling
screws on each reinforcement strap. Make sure to keep the tarp pulled tight to reduce
wrinkling. (FIG. 1-176)
#10-16 x 3/4” Pan
Head Self-Drilling
Screw (9005197)
U-Clamp
(9004949)
Reinforcement
Straps
1”
11 5/8”
Spline
Front
