Set to Off (O) and
plug in
3
BASIC PRODUCT MAINTENANCE
Hold card at edge
3
4
Set to Off (O) and
plug in
Feed into center of
entry and release
Set to Off (O)
Continuous operation:
3-5 minute maximum
NOTE:
Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3-5 minutes will trigger
15-minute cool down period.
Set to Auto-On (I)
OPERATION
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
* Apply oil
across entry
Set to Off (O)
PAPER
CARD
1
1
TROUBLESHOOTING
Paper jam:
Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or
all of the below procedures.
Alternate slowly back and forth
Set to Reverse (R)
for 2-3 seconds
Set to Off (O)
and unplug
Gently pull uncut
paper from paper
entry. Plug in.
Set to Reverse (R)
1
5
6
Shredder doesn’t start:
Make sure head is on basket correctly
Wait 15 minutes for motor to cool down
Remove and empty basket
Make sure safety lock is in
unlock position
Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.
Safety Lock prevents accidental operation. To set, wait for shredding to stop, push black button down and slide towards front of shredder.
To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.
15
1
2
1
5
Feed into paper
entry and release
Check paper amount
Set to Off (O)
Set to Auto-On (I)
1
2
1
3
1
5
1
1
4
2
3
4
1
2
Set to Reverse (R)
for 2-3 seconds
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 3 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
additional costs incurred by Fellowes to provide parts or services outside of the country where the
shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
for any consequential or incidental damages attributable to this product. This warranty gives you
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
except where different limitations, restrictions, or conditions may be required by local law. For
more details or to obtain service under this warranty, please contact us or your dealer.
LIMITED PRODUCT WARRANTY
3
