BASIC SHREDDING OPERATION
3
JAM BLOCKER SYSTEM OPERATION
Blocks jams before they start.
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
BASIC PRODUCT MAINTENANCE AND TROUBLESHOOTING
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished sheet
capacity, intrusive noise when shredding and could ultimately
stop running. To avoid these problems, we recommend you
oil your shredder each time you empty your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
*Apply oil across entry
Set to Off
3
SAFESENSE
®
TECHNOLOGY OPERATION
SET-UP AND TESTING
Press Auto On ( )
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active and
working properly
1
1
2
4
If hand is held on SafeSense
®
area more than 2 minutes
shredder will shut off
Indicator lights:
Wait 20 minutes for motor to cool down
Make sure bin is pushed in
Remove paper
Yellow - SafeSense
®
active
3
Press and hold Reverse
(
) 2-3 seconds
www.fellowes.com
features an extensive on-line support section with a number of self-service options
Press Auto On ( )
to activate
Feed paper/card
straight into paper
entry and release
When finished
shredding set
to OFF
PAPER/CARD
Plug in and put
disconnect power
switch in ON (I) position
2
1
3
4
Continuous operation:
10 minutes maximum
NOTE:
Shredder runs briefly after each pass
to clear entry. Continuous operation beyond 10
minutes will trigger 20-minute cool down period.
2
Paper jam:
Shredder will
automatically reverse the
paper out for easy removal
Reduce paper quantity
to an acceptable
amount and refeed
into paper entry
3
1
If Remove Paper icon ( )
is illuminated, there is too
much paper for the shredder
to power through
