16
BASIC SHREDDING OPERATION
16Ms: Continuous operation:
Up to 20-minutes maximum
NOTE:
Shredder runs briefly after
each pass to clear entry. Continuous
operation beyond 20-minutes will
trigger 15-minute cool down period.
20Ms: Continuous operation:
Up to 30-minutes maximum
NOTE:
Shredder runs briefly after
each pass to clear entry. Continuous
operation beyond 30-minutes will
trigger 10-minute cool down period.
3
Press ON ( ) to
activate (white)
Feed paper/card
straight into paper
entry and release
Plug in and put
disconnect power
switch in ON (I) position
When finished
shredding set
to OFF ( )
Press and hold forward ( )
2-3 seconds
PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
.
All micro-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
TO CLEAN THE SENSORS
Turn off and unplug
shredder
Locate Auto-start
infrared sensor
Dip cotton swab in
rubbing alcohol
Using cotton swab, wipe
away any contamination
from the paper sensors
For more information about all of Fellowes Advanced Product Features go to
www.fellowes.com
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain
illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and
recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. Close the bin to resume shredding.
Remove Paper: When illuminated, press reverse (
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
®
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
TROUBLESHOOTING
3
2
1
1
2
4
1
3
SafeSense
®
is active and
working properly
SAFESENSE
®
TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
Touch test area and
look for the SafeSense
®
indicator to illuminate
Turn the shredder
ON ( ) to activate
SafeSense
®
SET-UP AND TESTING
ADVANCED PRODUCT FEATURES
2
2
1
4
4
3
If hand is held on SafeSense
®
area more than 3 seconds,
shredder will shut off
PAPER OR
CARD
16Ms
16
SafeSense
®
Technology
Stops shredding immediately when
hands touch the paper entry.
Auto Reverse
Stops and reverses paper if a
jam occurs.
