Page 6
Step #7: attach feet to left and right legs
• Place the rectangular opening on the foot over the leg. The short end of the foot should be toward the rear of the table.
• Use the remaining eight M6x15 socket cap screws and 5mm Allen key to secure the feet in position.
• When installed correctly, the rear of the feet align with the rear of the table.
VictoryLX 3-leg
Assembly
Step #6: attach center leg to frame
• Position the center leg (the one with the glide attached) into the center leg bracket, similar to the way the outer legs were positioned.
— First lower the protrusions on the motor housing into the notches.
— Then push the protrusions back into the narrower part of the notches.
• Install the remaining cam lock. With the lever arm upward, insert the long end of the cam lock first, as shown.
• After the cam lock is installed, rotate its lever arm toward the leg until the lever is horizontal to lock the leg in place.
• Install the remaining cotter pin to secure the cam lock.
• Check to be sure each leg is securely locked in position.
CAUTION:
The cam locks must be in the locked position at all times to secure the legs in place.
position leg
in bracket
install cam lock,
long end first
route motor cable
under bracket
secure
with cotter pin
rotate lever
to lock leg
rear
front
5mm Allen key
M6x15 socket cap
feet will align
with rear of table
foot
for
24" t
able
foot fo
r
30" ta
ble
glide
