Fellowes esi LOTUS-RT1-BLK, Инструкция по сборке и эксплуатации

Страница: 8 / 12

Lotus RT product assembly/cord management
step 6 (optional)
Adjust platform level
• Activate lever and move unit to desired sitting position (image B).
• The worksurface is assembled to be level, however certain setups may show lifting of the corners
(Image C). In order to adjust the surface, follow the steps below.
— Determine if the left or right side is lifting up.
— Engage the lever and raise the worksurface.
— On the lower side of the surface, loosen the (2) M6 nuts on the underside of the platform using a
10mm wrench (H).
— On the same side, tighten the M4 adjustment screw (image E) using the 4MM Allen Key (C) until the
worksurface is level.
— Re-tighten the two M6 nuts.
— Lower the worksurface back to the sitting position. If the surface isnot to the desired setting, repeat
steps above untilsurface is level.
Image A
Image C
Image B
Image D Image E
H
C
Page 8
step 5
Attach Monitor(s)
• Attach your monitor(s) to the VESA assembly using the
included Phillips pan head screws M5x12mm (F) or M4x
12mm (G), depending on your monitor.
G
all 4 corners