Cutting Directly At the Wall
Thanks to the elasticity of bi-metal saw blades it is possible to cut pipes flush with wall.
To do so,
use a saw blade of sufficient length that exceeds the diameter of the pipe. Position the point
of
blade tip to be
outside the workpiece to be cut.
Plunge Cuts
The saw is suitable for plunge cuts in wood and plastic. Use only short saw blades (<150mm) to
perform plunge cuts!
Switch on orbital stroke to perform plunge cuts.
Place the saw on the workpiece with the bottom
edge of the cutting support in such a way that the saw blade does not touch the workpiece.
Switch on the saw
and press the cutting support firmly against the work piece and swing the saw
forwards. Slowly plunge the saw blade into the workpiece. When the cutting support is resting
fully on the workpiece, continue cutting along the desired cutting line.
NOTE:
Do not perform plunge cuts in metal.
Maintenance and Cleaning
NOTICE:
Never use gasoline, benzine, thinner, alcohol, or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment
should be performed by professional persons. Always use correct replacement parts.
Before any work on the machine itself (e. g. maintenance, tool change, etc.) as well as, during
transport and storage, remove the battery from the power tool. There is danger of injury when
unintentionally actuating the On/Off switch.
For safe and proper working, always keep the machine and ventilation slots clean.
Battery packs/ batteries
Protect the battery against moisture and water.
Store the battery only within a temperature range between
32
°
F
and
110
°
F (0° C and 50° C)
. As
an example, do not leave the battery in
a hot
car in summer.
Occasionally clean the venting slots of the battery using a soft, clean, and dry brush.
Please observe the instructions in section “Transport” and the notes for disposal.
Tips for Maintaining Maximum Battery Life
1.
Charge the battery cartridge before it is completely discharged. Always stop tool operation and
charge the battery cartridge when you notice less tool power.
2.
Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life.
3.
Charge the battery cartridge with room temperature at
50
°
F
-
104° F
(
1
0°
C
-
4
0
°
C
). Let a hot
battery cartridge cool down before charging it.
4.
Charge the battery cartridge if you do not use it for a long period (more than six months).
10
Содержание P52246
Страница 1: ...150 18 3 F52246 RU EN CORDLESS SABRE SAW...