8
9
The care you take in reading and following this instruction will
probably determinate the satisfactory service you will receive from
your Furnace.
UNPACKING.
Carefully remove the Equipment from the shipping case. Preserve all
paper work for future reference. If damage has occurred from shipment a
claim must be filed with the carrier immediately; preserve the shipping
container for inspection by the carrier. Contact your dealer or Felisa.
INSTALLATION.
Install your Furnace using a connection of the adequate voltage. See the
label specification before connecting. The Furnace can be installed on
any surface or table sufficiently firm and strong, leaving a minimum
space of 10 cm. Between the Furnace and any other vertical surface
Keep the area around free of any material to allow ventilation in the area
of the bottom. For correct operation it is necessary that the user
becomes familiarized with all the available controls and specifications
shown in each model.
LOAD IN THE CHAMBER
.
It is very important not to overload the chamber. For the right heating of
the load, it should occupy no more than 2/3 of any dimension of the
chamber. The Furnace heats up any load by radiation and will heat as
fast as it absorbs this energy. Try to center the load, the Furnace can not
be forced without risk of damage.
FURNACE OPERATION
.
Control general description.
The control has implemented a Fuzzy algorithm to control the
temperature, has a graphic display and a serial communication port for
sending data to either a terminal or a thermal printer (optional depending
on each model).
BUTTONS DESCRIPTION
.
Cancel
: This button returns you to the previous menu and abort a
running cycle.
Set
: Selects between the operations of each screen.
Above
: Increases the selected parameter.
Down
: Decreases the selected parameter.
MENUS.
1 Start
2 Cycle
3 Cycle type
4 Configuration
5 Print – Graphic
6 Calibration
.
CONTROL ON
To turn the control on, press the switch to on position . Immediately
following will print the screen (1) for a few seconds, the operating system
will recognize the operation of the temperature sensor, the strength and
integrity of the line voltage. Upon completion of these tasks will hear a
beep and the review screen print (2). The control system requires to
connect to a line grounded to avoid electrical noise problems, also the
control system makes detection to line and verify that the supply voltage
is correct.
(1)
(2)
felisa
R
www.felisa.com.mx
