23
1
2
&
%
!
"
%
#
$
6 - 16
mm
6 - 20
> 16
> 20
FB 710
min 3 mm
FB 510-610
1/2 1/2
"
!
Bandsaw
FB 510/610/710 & FB 710 c-tech
7.3 Saw blade replacement/tension
Fig. 7-3: Saw blade replacement
7.4 Table pad and wooden pad for dust extraction
Fig. 7-4: Table insertand Wooden pad
!
Table insert
"
Wooden pad
Table insert:
The machine is equipped with a plastic table pad. The
holes in this pad facilitate the task of extracting dust. The
height of the table padding can be adjusted exactly to
table level with the 4 adjusting screws in the table open-
ing.
Wooden pad:
Turn the wheel manually.
Push the wooden pad into the guides until it stops.
To maintain the extraction capacity, change the wooden
pad if the cutting gap is getting too large.
Operation
1.
Disconnect the machine from the mains supply.
2.
Remove table insert and positioning pin.
Open wheel door.
3.
Loosen the blade tension hand wheel by turning it
clockwise. Unthread old blade through the machine
table.
4.
Place new saw blade over both wheels (note the di-
rection of the cut!).
Release the clamping lever and set the saw blade
track using the hand wheel:
see sketches
5.
Turn the wheels manually and ensure that the saw
belt glides properly around the wheels and does not
collide with any solid machine parts.
6.
Clamp the clamping lever.
Check the saw blade tension and if required, adjust
with the hand wheel. The values refer to the saw bla-
de width.
!
Positioning pin
"
Table insert
#
Handwheel - Saw blade track
$
Clamping lever
%
Blade tension hand wheel
&
Scale
