Guilin Feiyu Electronics Co., Ltd.
Page | 3
Figure 2:
Solder (
red arrows
) the 3 arms onto the bottom fuselage plate:
\
1.
Note the fuselage plate has a side “A” and “B”. Ensure side “A” is always facing
upwards.
2.
In this step, use the fuselage with electronics installed. Solder all 4 arms to this plate
(Figure 4).
1.
Proceed with installing the 3 arm sets as shown above.
2.
Caution:
Do not overheat the arm contact points, as the metal will deform making
it difficult for arm insertion into the fuselage plate.
3.
To check LED light function, connect a 3S Lipo balance plug to the socket at the
bottom of the fuselage; the LEDs will light up. You may also check with a DC
meter at the solder point; it should indicate approximately 2.3 Volts.
Figure 4
Cross any two wire ,
change Motor rotation
Solder points
ESC
Bottom
plate
with
Electronic
components
Cable tie through
square
groove to
hold ESC to frame.
M3
×
25mm Pillar
