Fein WSB 8-115, Инструкция по эксплуатации

Страница: 19 / 176

WSB 8-115 / WSB 13-125
19
EN
Do not restart the cutting operation if the cutting
wheel is in the workpiece. Let the cutting wheel
reach full speed and then carefully reenter the
cut.
The cutting wheel may bind, jump out or
kick back if the power tool is restarted with the
cutting wheel in the workpiece.
Support the panels or any oversized workpiece to
minimize the risk of wheel pinching or kickback.
Large workpieces tend to sag under their own
weight. Supports must be placed under the
workpiece near the line of cut on both sides of
the cutting wheel and at the ends of the work-
piece.
Use extra caution during “plunge cuts" in walls or
other blind areas.
The penetrating cutting wheel
may cut gas or water conduits, electrical wiring
or objects that could cause kickback.
Safety instructions, particularly for sanding
work with a sanding disc.
When sanding, do not use an excessively over-
sized sanding disc. Follow the manufacturer’s rec-
ommendations when selecting sanding discs.
Sanding discs larger than the backing pad present
a laceration hazard; they can tear, cause snag-
ging, rip off from the backing pad or cause kick-
back.
Special safety instructions for sanding work
with wire brushes.
Be aware that wire bristles are thrown by the
brush even during normal operation. Do not over-
stress the wire bristles by applying excessive load
to the brush.
The wire bristles can easily pene-
trate light clothing and/or the skin.
If the use of a guard is stipulated for sanding with
wire brushes, do not allow the wire bristles to con-
tact the guard.
The wire brush may expand in
diameter due to the work load and centrifugal
forces.
At a glance.
The following numbering used for the
operating elements relates to the figures
at the beginning of this Instruction Manual.
1 Quick-clamping lever
For clamping the accessory.
2 Pressing surface (4x)
For starting the angle grinder.
3 Auxiliary handle
Hold the power tool with both hands.
4 Clamping unit
For clamping the accessory.
5 Locking lever (5a) for guard (6c)
For loosening/tightening the guard.
6 Standard accessories
Clamping unit for grinding and cutting
wheel (6b),
Guard (6c),
Auxiliary handle (6d).
Only part of the accessories described or shown
in this instruction manual will be included with
your power tool.
Intended use of the power tool.
This power tool is intended as a hand-guided
grinder for commercial use, for dry-sanding/
grinding and cutting metal and stone in weather-
protected environments using the application
tools and accessories recommended by FEIN.
Operate the power tool only with the voltage
rating as printed on the nameplate of the
machine.
This machine is also intended to be powered by
a.c. generators with sufficient power output that
correspond with ISO 8528, design class G2.
Compliance with this Standard in particular is
not given when the so-called distortion factor
exceeds 10%. When in doubt, inform yourself
about the generator in use.
Operating instructions.
Mounting the auxiliary handle (Figure 3).
➤
Screw the auxiliary handle tightly onto
the left or right side of the power tool,
depending on the working method.
Adjustments.
Adjusting the guard (Figure 5).
➤ Press the locking button (5a) upwards
and keep it pressed.
➤ Swivel the guard (5) into the required
working position.
➤ Let go of the locking button (5a) and
engage the guard (5).
3 41 01 048 06 4.book Seite 19 Donnerstag, 20. Juli 2006 2:18 14