14
en
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
respective application.
Switching on and off (figure 5).
Always hold the power tool
firmly.
Otherwise, you could
lose control over the power tool.
Guide the power tool toward the work
piece only when switched on.
Switching on:
Push the switch toward the front
(I)
.
Switching off:
Push the switch toward the rear
(
)
.
Setting the oscillating frequency
(figure 6).
Adjust the oscillating frequency infinitely vari-
able with the dial control.
Turn the dial control between
“1”
for the
lowest speed and
“6”
for the highest speed.
WARNING
CAUTION
CAUTION
Fig. 5
On/Off switch
Thumbwheel for pre-selection
of oscillating frequency
Fig. 6
OBJ_BUCH-0000000156-002.book Page 14 Friday, October 17, 2014 10:43 AM
