![Fein CG13-150 Скачать руководство пользователя страница 17](http://html1.mh-extra.com/html/fein/cg13-150/cg13-150_instruction-manual_3925491017.webp)
17
en
Changing the tool.
Before mounting or replacing cutting tool or accessories, pull the power plug.
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Mounting a grinding disc (figure 4).
Press the locking button only when the
motor is stopped.
Press the locking button fully through and
hold it in place. Loosen the quick-clamping
nut.
Unscrew the quick-clamping nut.
Replace the used-up grinding accessory
or insert a new one.
Pay attention that the grinding acces-
sory is properly centered between the
support flange and the quick-clamping
nut.
Manually screw the quick-clamping nut on
again.
Press the locking button fully through and
hold it in place. Tighten the quick-clamping
nut.
Note:
Observe the mounting direction of the
quick-clamping nut.
Offset grinding discs must be mounted in
such a manner that their grinding surface is
2 mm below the bottom edge the of the
wheel guard.
Grinding accessories that do
not meet these requirements cannot be ade-
quately covered off and are not permitted.
WARNING
Fig. 4
1.
3.
4.
2.
2.
4.
3.
1.
Содержание CG13-150
