17
en
Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
tery.
This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the
respective application.
Switching on and off (figure 8).
Always hold the power tool
firmly.
Otherwise, you could
lose control over the power tool.
When overheated, the machine runs with
short, low-power impulses. Allow the
machine to cool down at no-load speed.
For stationary use in a drill stand, remove the
switched off power tool from the drill stand
at operating temperature every 50 operating
hours and turn it by 180° to achieve uniform
lubrication.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Locking on:
Press the On/Off switch to the stop and press
in the Locking button.
Release the On/Off switch.
For switching off, briefly press the On/Off
switch until the Locking button disengages.
Release the On/Off switch.
WARNING
CAUTION
CAUTION
1.
1.
2.
2.
3.
Fig. 8
On/Off switch
Locking button
OBJ_BUCH-0000000365-001.book Page 17 Monday, February 11, 2019 10:03 AM
