7
ALIGNING THE LASER GUIDE LINE
DANGER:
Laser radiation. Avoid direct eye contact with light source
WARNING:
Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposures. When you adjust the laser please don’t tune on
switch. Fig.10. Otherwise starting the blade can be dangerous.
1. Adjusting the laser: Tighten or loosen the (A), for adjusting the laser indication direction.
Adjusting tooling: M2 HEX wrench (A) as Fig.11
2. Adjusting the laser indication direction to be same line as cutting line. Adjusting tooling: parallel
screw driver (A) Fig.12
3. Adjust the laser line (B) on the notch (C) then set up the bevel scale at the 0
∘
position. Fig.13
How to use LED light
LED is used when the condition is dark and user
can see the work piece and blade from the window.
‧
Push the LED button(A) to start the LED light,
push again to turn off, as Fig.14
Fig.11
A
B
Fig.12
A
B
Fig.13
B
C
Fig.10
Fig.14
A
B